router config to work with VNC

Tom Knowlton tom "at" buyersfund.com
Thu Mar 25 16:38:01 2004


A lot of the symptoms you have described are true:

I have to connect to either the DLink router OR the ActionTec broadband modem seperately in order to run 192.168.0.1 and get to the config.  That means they are both using 192.168.0.1, which as you said....sounds like an unhappy time for the DLink router.  :)


Tom



-----Original Message-----
From: coulter [mailto:coulter "at" coulter.ndo.co.uk]
Sent: Thursday, March 25, 2004 6:36 AM
To: vnc-list "at" realvnc.com
Cc: Tom Knowlton
Subject: RE: router config to work with VNC


As noted by other posters your diagram is incomplete.

However what if does tell me is that you have two devices - namely the Actiontec modem and the D-link router - with the same IP address namely 192.168.0.1 (you say it in words in some of the supporting text but it is not shown in the diagrams).

First you can't have two devices with the same IP address and not expect problems.
Plus your Dlink must be getting very confused -- it's supposed to be a router, by definition a router routes! Usually between different sub-nets!! :-)
But as it is seeing the same IP address 192.168.0.1 on each of its port (both WAN-side and LAN-side) it's likely not a happy bunny.
  
For me the easiest way to solve this is to put the modem and the router on different sub-nets as follows: 
leave the  modem on 192.168.0.1 (the 192.168.0.0/255.255.255.0 sub-net) and put the router on a completely different sub-net. So that it is very clear which is which make them very different, thus I suggest putting the router on the 10.0.0.0 / 255.255.255.0 (although really anything other than 192.168.0.x will do). The router being the DHCP server then dishes out LAN IP address to this revised sub-net. The very first consequence of this will be that you can access both devices via IE using their now different IP addresses without having to be disconnect the devices every now and again! ;-) 

Once you get this difficulty between modem and router sorted you may be able to progress with VNC issues. Set up port-forwarding on each device now as appropriate. 
 
Good luck,
P

> --__--__--
> 
> Message: 14
> Subject: RE: router config to work with VNC
> Date: Wed, 24 Mar 2004 17:13:21 -0700
> From: "Tom Knowlton" <tom "at" buyersfund.com>
> To: "Scott C. Best" <sbest "at" best.com>, <vnc-list "at" realvnc.com>
> 
> Does this diagram help any?  (until I can get Kaboodle up and running)
> 
> 
> http://www.knowltonfamily.com/config_port_forward.gif