Digitus router problem with VNC

[JM Soler]

Hi Steve:

Try setting ports 5500 and 5800 also, setting the forwarding to the private
IP at the router NAPT configuration.

You should know wich public ip have been asigned to you each time, so maybe
can help surfing to the clasical web that says: "your ip is.." and then use
this ip in the viewer to test it.

Hope it helps a little. Good luck,

Jose Soler

----- Original Message -----
From: "Scott C. Best" <sbest@best.com>
To: <vnc-list@realvnc.com>
Cc: <taozensteve@yahoo.com>
Sent: Tuesday, April 08, 2003 2:45 AM
Subject: Re: Digitus router problem with VNC


> Steve:
>
> Heya. Try these suggestions out:
>
> http://faq.gotomyvnc.com/fom-serve/cache/64.html
>
> Those pages describe how to get VNC running from behind a
> firewall/router, how to test and debug the setup, etc. I hope
> it proves useful!
>
> -Scott
>
> > I am also trying to configure my router to open a port to pass packets
> > through.  Under Special applications, I have port 5900 opened to send
> > and recieve, but when I put my IP xxx.xxx.xxx.xxx:0 the viewer cannot
> > connect.  I am not sure what else to do.  My ISP (Deutsche Telekom)
> > assigns me a dynamic address, and I am using W2K on all machines.
> >
> > Any assistance would be appreciated.
> >
> > Thanks
> >
> > Steve
> _______________________________________________
> VNC-List mailing list
> VNC-List@realvnc.com
> http://www.realvnc.com/mailman/listinfo/vnc-list